|
TOOL
HOLDERS:
CENTAUR:
An
economical line of collets and tool holders. One of the most
complete sources of collets in the industry including ER, TG, RDO,
RDA, AF, 5C, R8 and tapping collets. Collet chucks with a variety of
nose nuts as well as tapping holders are in
stock.
COMMAND:
Command offers a wide line of USA
made precision tool holders and unique machining accessories.
Holders are available in BT, CAT, and HSK style endmill holders,
collet chucks, shell mill holders and tap holders, as well as shrink
fit systems. Fluid drive keyway cutters, right angle holders, CNC
presetters, and taper checking fixtures are available also. Command
offers balancing capabilities to balance and certify less than 3
g.mm on assemblies.
ISCAR:
Iscar's ETM line offers
many innovative solutions for your machining needs. Short-in,
click-fit, and shrink-in, are Iscar's improved connections that
minimize runout and vibration in the CAT, BT, ISO, or HSK tool
systems. The innovative FitBore holder will allow your indexable
drill's drilling diameter to be adjusted within a .063" range,
allowing you much greater flexibility with your machining operation.
Iscar also offers a complete line of R8 and straight shank tooling,
as well as floating holders for reaming and
tapping.
FETTES MANUFACTURING CO.:
Fettes offers
high precision ball drive, quick change tap drivers and collets. Tap
holders will accept bilz-style collets and are available as rigid or
tension/compression style. All collets are made from premium 4l40
hardened and ground for precision operation. Holders are available
in chuck sizes #1, #2 or #3, and in shank sizes of CAT, BT, straight
or automotive.
OSG:
OSG offers a very economical
shrink system of holders. The electric hot air heating unit is the
lowest cost unit on the market which allows you to enter into the
"next generation of tool holding" with the lowest initial cost.
Holders are made with CAT, BT or HSK style
shanks.
TECHNIKS:
Brand new SlimFit system allows
you to use either shrink fit holders or collets in the same master
shank. The slim and short holders engage the collets by use of an
internal draw bar. This short holder can provide a maximum TIR of
.0002" at 4x diameter. Techniks also offers a full line of CAT, BT
and HSK holders, as well as CNC router collet holders and pull
studs.
|
